Nearly all of the time, businesses will spend a lot of money to purchase their forklifts. It is vital, therefore to take proper care of your machinery to protect your investment into the long run. It is a good idea to know the procedures that are carried out during taking care of and maintaining this machine.
By starting up the forklift and listening carefully how it works is one of the best ways to tell how good the engine is running. Like for example, if there are any knocks or misses, the machine is faulty and this must raise several concerns. Furthermore listen closely for any squealing noise which come from the belts because these sounds will provide you with a wealth of information.
When performing maintenance, some of the main parts you would need to pay attention to consist of the safety warning devices, horn, the overhead guard, the lights and the gauges. Any faulty parts or burnt out light bulbs have to be replaced as soon as they are noticed. It is also vital to check the wiring.
After the above parts have been inspected thoroughly, proceed to the battery compartment to be able to see if the terminals are clean. If the terminals are not clean, be sure to clean them well. Every battery cell should be inspected in order to make sure that the fill level is topped up to the regulated amount.
An oil change is the next step to drain all the oil out of the equipment and then change the filters. The hydraulic filter, the transmission filter and the fuel filters should be replaced on a regular basis. Prior to fitting them, be sure to write the date on the new filters by utilizing a permanent marker in order to keep track.
When the oil change is done and the filters have been replaced, a visual inspection of the drive axle has to be carried out. If there is a grease fitting on the axle make certain to apply some grease. Inspect the engine belts for any cracks or frays. If you find any, fix the problem accordingly. Afterwards, check each and every other part of the machine like the wheels. If any type of concern or fault is detected, be certain to address it immediately so as to make sure the equipment is working at its safest and optimum levels.