Change a Propane Tank
Propane powered forklifts are normally used in warehouses. The forklift is made with the propane tank mounted at the back of the operator. The tanks, which look a lot like beer kegs, need to be replaced from time to time since they have a limited lifespan. Drivers of forklifts must use care when handling propane tanks. Compressed gases are really hazardous, specially because the gas is flammable. Utilize care when replacing and removing propane tank to avoid being injured.
1 If there is a need to change the propane tank, the first step is to stop the lift truck, then turn the tank valve off. The lift truck should be left on until the engine dies. This procedure burns off the gas inside the transfer hose that connects the tank and the engine. Prior to taking the next steps, wear the correct safety equipment, like insulated gloves made of either neoprene or leather. It is very important for you to protect your skin from contact with the compressed gas, which is very cold.
2 The tank hose has to be disconnected, followed by removing the tank from its holding straps. When putting in a new tank, tighten the nut to reattach the holding straps and to reconnect the hose at the valve of the tank.
3 Leaks could be checked simply by applying soapy water to the valve and opening it slightly. If there is a leak, it will cause bubbles to froth from around the valve. If this happens, check the valve area and the connection hose at the nut. Re-tighten the connecting nut if you detect any leaks around the valve area, and then perform the leak checking process once more. Persistent leaks mean that the nut and connecting hose should be replaced. Then again, if replacing the nut and hose still does not stop the leak, the tank would need to be replaced.
4 Finally, open the valve all the way to enable the gas to fill the connecting hose. After that you could start the lift truck and resume operating.